clare ClareOne Installation Sheet

clare ClareOne Installation Sheet

Ceiling mount 360 pir

Advertisement

Quick Links

ClareOne Ceiling Mount 360 PIR Installation Sheet
Last modified: 10/22/20
Part Number: CLR-C1-360PIR

Description

The ClareOne Ceiling Mount 360 PIR sensor is a passive
infrared motion detector designed for ceiling mount.
The compact design allows for easy installation while the
sensitivity settings provide adaptability for different
environments.
The motion detector is designed for a ceiling mount application
that provides a 360° detection range.
Notes
Do not mount the sensor outdoors.
Avoid areas with pets.
Do not mount the sensor near ceiling fans or heating
ducts.
Avoid placing the sensor in sight of windows and direct
sunlight.

Installation

Before installing the sensor, carefully select the desired
location and sensitivity settings.

Location

The sensor's coverage pattern is dependent on mounting
height. Areas can be masked off to prevent unwanted
detection.
Mounting height
Detection area
8 ft (2.4 m)
20 ft (6.09 m)
10 ft (3.04 m)
30 ft (9.14 m)
12 ft (3.65 m)
45 ft (13.71 m)
Detector sensitivity can be set to allow for harsher
environments with varying temperatures.
© 22OCT20 Clare Controls, LLC.
Figure 1: Detection area

Sensitivity setting

The sensor has 2 sensitivity settings: low and high.
Low (Lo): The recommended setting, allows for some
environmental movement.
High (Hi): A quick response, used for quiet areas that do not
expect environmental noise.
To select the sensitivity level:
1.
Gently twist the sensor top and pull the domed top away
from the base.
2.
Place the jumper into the desired sensitivity level (Lo or
Hi).
Lo Sensitivity: Jumper placement in the top two pins.
Hi Sensitivity: Jumper placement in the bottom two pins.
3.
Replace the sensor top, twisting it firmly into place.

LED

The LED jumper is used to enable/disable a red LED to
illuminate when movement is detected. The red LED does not
illuminate unless the LED jumper is installed across the pins.
Note: Leaving the LED jumper installed greatly reduces the
sensor's battery life.
1 / 4
DOC ID – 1996 • Rev 01

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ClareOne and is the answer not in the manual?

Questions and answers

Summary of Contents for clare ClareOne

  • Page 1 Figure 1: Detection area Last modified: 10/22/20 Part Number: CLR-C1-360PIR Description The ClareOne Ceiling Mount 360 PIR sensor is a passive infrared motion detector designed for ceiling mount. The compact design allows for easy installation while the sensitivity settings provide adaptability for different environments.
  • Page 2 The batteries used in this sensor are lithium batteries and are not reusable. Properly dispose of used lithium batteries Put the ClareOne panel into sensor paring mode. For according to your local hazardous waste disposal laws. detailed programming instructions, refer to...
  • Page 3 EN 54 EN 54-00:0000 connected. European Union 1999/5/EC (R&TTE directive): Hereby, Clare •Consult the dealer or an experienced radio/TV directives Controls declares that this device is in technician for help. compliance with the essential requirements and This device complies with Industry Canada other relevant provisions of Directive 1999/5/EC.
  • Page 4 Warranty information Clare Controls offers a two (2) year limited warranty on original Clare Controls components, from the date of shipment from Clare Controls. Contact information Clare Controls, LLC. 7519 Pennsylvania Ave, Suite 104 Sarasota, FL 34243 General: 941.328.3991 Fax: 941.870.9646 www.clarecontrols.com...

This manual is also suitable for:

Clr-c1-360pirClr-c1-pnl1

Table of Contents