Pro-Ject Audio Systems Debut Carbon EVO Preparation Manual
Preparing your for shipping
Hide thumbs
Also See for Debut Carbon EVO:
- Setup manual (2 pages) ,
- Instructions for use manual (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Pro-Ject Audio Systems Debut Carbon EVO
Summary of Contents for Pro-Ject Audio Systems Debut Carbon EVO
- Page 1 Preparing your Debut Carbon for shipping...
- Page 2 When shipping your Debut Carbon, it is important to package the turntable properly. Using the OEM box and packaging will help minimize the possibility of damage while it is in transit.
- Page 3 Getting your turntable ready for shipping There are a few items we want to remove from the turntable before placing it in the shipping box: • Remove the dustcover • Remove the anti-skate weight and the counterweight from the tonearm •...
- Page 4 Prepping the motor for transit • If your motor transport screws are installed, that’s great! If not, replace the TPE dampers and screw down the motor flange until it’s snug in order to secure the motor to the plinth.
- Page 5 Securing the tonearm With a standard bread tie, twist around the tonearm rest once and then again above the tonearm itself. This will prevent it from dislodging in transit and potentially damaging your cartridge and/or stylus.
- Page 6 Place on the front of the cartridge first and press up on the back of the guard until it clicks into place. This protects the most fragile part of the turntable. Place stylus guard on cartridge...
- Page 7 Packing items into the There is an order in which to place the items into the box. Please follow this diagram. It is also found on the last page of your manual for reference.
- Page 8 • First, place the platter on the bottom of the box. Place the Counterweight two foam inserts on the short ends of the box. • Place the counterweight in the foam inset and tape down with packaging tape. Let’s start packing the box...
- Page 9 Box up the power supply and place in the corner pocket. Place styrofoam bricks on top of the PSU box.
- Page 10 Now add the plinth (and sub-platter) into the box. Use enclosed fabric cloth to protect the finish.
- Page 11 Place the cardboard triangle on top of the sub platter • The cardboard triangle will prevent the sub platter from coming loose from the spindle bearing cup. This little piece will prevent damage to your turntable plinth.
- Page 12 Setting the dustcover in the box • Using the supplied cardboard pieces, place the short ends of the dustcover into the cardboard end caps as shown. If you have a fabric sleeve for the dustcover, go ahead and put it on before placing the dustcover into the carboard end caps.
- Page 13 Now place cardboard sheet on top of the dustcover...
- Page 14 Please include your RCA phono cable and drive belt along with any remaining accessories that came with your turntable. Set the accessories kit on top of the cardboard...
- Page 15 Close up the box and tape down the flaps. We strongly suggest placing the turntable in a second box with packing material such as bubble wrap or sheet foam for additional protection. Please ship your turntable to: SUMIKO Service 6655 Wedgwood Road N Suite 115 Maple Grove, MN 55311-28140 Be sure to include you RA# prominently on the outer box or on your...