Pro-Ject Audio Systems Debut S Setup Manual

Debut S Debut S
Debut S Phono Debut S Phono
Setup Guide Setup Guide
Start with this side Start with this side
1 1
Unpack all items from accessory bag. Unpack all items from accessory bag.
a) Connect it E – RCA cable a) Connect it E – RCA cable
b) Standard 昀氀 at belt for 33/45 RPM b) Standard 昀氀 at belt for 33/45 RPM
c) Cartridge alignment protractor
d) Round belt for 78 RPM
e) Adapter for 7" singles,
Allen key 1.5mm for azimuth setting
4
Carefully remove the protection covering.
Tonearm is fragile!
Put the 昀氀 at drive belt on the small pulley
8
and sub-platter.
Small pulley 33/45 RPM
Large pulley 78 RPM
Remove the stylus protection
12
cover.
Turn the front dial of the counterweight
16
(not the whole weight) so the '0' is in line
with marker at the back of the tonearm.
20
Plug in power supply.
d) d) d)
c) c)
a) a) a)
b)
e)
e)
5
Unpack the counterweight.
9
Put the platter on the turntable.
13
Put the felt mat on the platter.
Turn the whole counterweight counter-
17
clockwise until the scale reads 18 - 20.
21 Use the rocker switch on the bottom
left to select the playback speed.
RIGHT: 45 RPM / 78 RPM
LEFT: 33 RPM
STOPS THE MOTOR
> Getting star > Getting started:
• Make sure to have enough space to unpack • Make sure t
• Always unpack and set up in a clean • Always unpack and s
• Please Do NOT throw away the packaging! • Please Do
2 2
Remove dust cover carton from the box. Remove dust cover carton from the box.
6
Unpack the power supply.
10
Remove tonearm twist tie.
Put a record on the platter and place the
14
tonearm between platter and armrest.
18
Set the Anti Skating Force scale to 2.
Balance the tonearm so it stays level by Balance the tonearm so it stays level by
turning the counterweight forwards and turning the counterweight forwards and
backwards on the rod. backwards on the rod.
22
How to connect + possible setup on the backside of this sheet.
your turntable. your turntable
enviroment enviroment.
If you need s If you need service or want to return your
product, pleas product, please send them in the original
packaging including all ins packaging including all inserts. In case of
any damage in another packaging y any damage in another packaging your
dealer cannot guar dealer cannot guarantee a full refund.
3
Lift the wrapped turntable out of the box.
7
Unpack the platter.
11
Screw the counterweight in place.
Balance the tonearm so it stays level by
15
turning the counterweight forwards and
backwards on the rod.
0
Unpack dust cover and put it on
19
the turntable.