INNOVAPLAS Lumi-o BILTMOR DECK 5050 Manual

Contents of the Biltmor box SKU # 5050

x2
x2
x4
Install the step on a flat surface.
Do not jump or dive from the step.
Remove the step from water when temperatures drop below freezing.
In winter, the step should be stored in an area protected from snow.
Never lift the step by its handrails.
Use BATTERY operated tools to avoid electric shock near water.
Ensure no corrosive materials are added to the step or harware kit.
The step must be installed per manufacturer's instructions.
File off all stripped or sharp edges before assembly to avoid injuries
and liner damage.
The manufacturer is not responsible for damages or injuries caused
by improper installation or use of product.
To ease the installation of handrails and bolts, use a screwdriver to
line up the holes.
BILTMOR DECK 5050
x2
x4 x2
x2

WARNING

A
A
x6 x6 x6
INSERT NUT
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
SCREW BAG 140-0067
A B C D E F
x6 x6 x6 x24 x2 x12
1) Insert the two gussets in the slots and slide them
toward the corners.
2) Assemble the two main modules with the six screws,
nuts and washers provided.
3) Snap the door between the top and bottom module
within the slots provided.
B C
GUSSET
2X
REV. 02/26/2020

Contents Riser kit

SCREW BAG 140-0010
x2
x2
Required tools (not included)
Phillips #2 7/16 wrench
Phillips #3
Sand

MANUFACTURER WARRANTY

1 year on pool step.
1 year on hardware.
PN:
D
x4
x4
Phillips bit
(not included)
PG:1