Check The Leds - ActionTec 54 Mbps Wireless Network Camera User Manual

Activating the LAN interface disables the wireless interface,
because only one interface can be active. The LAN interface is
recommended for initial configuration.
The default wireless settings for the Camera are:
Mode: Infrastructure
ESSID: Actiontec
WEP: Disabled
3. Adjust the Antenna
Screw the antenna to the rear mounting point of the Camera, then adjust the antenna to an
upright position to improve wireless reception.
4. Power Up
Remember, before connecting the power adapter, the LAN cable must be connected to the
Camera.
Connect the supplied power adapter to the Camera and power up. Use only the power
adapter provided. Using a different one may cause hardware damage.

4. Check the LEDs

•
The Ready LED will turn on briefly, then start blinking. It will blink during startup, which
takes 15 to 20 seconds.
After startup is completed, the Ready LED should remain ON.
•
The Active LED should be OFF.
It will flash when anyone is viewing live video.
•
Either the LAN LED OR the Wireless LED should be ON.
For more information, refer to "Front Panel" in Chapter 1.
7