Chapter 2 Basic Setup; System Requirements; Installation - ActionTec 54 Mbps Wireless Network Camera User Manual
Actiontec 54 mbps wireless network camera wireless-network camera: user manual
Hide thumbs
Also See for 54 Mbps Wireless Network Camera:
- User manual (45 pages) ,
- User manual (37 pages) ,
- User manual (41 pages)
Table of Contents
Advertisement
Chapter 2
Basic Setup
This chapter provides information about installing and configuring the
Actiontec 54 Mbps Wireless Network Camera.
System Requirements
•
To use the LAN interface, a standard 10/100BaseT hub or switch and network cable is
required.
•
To use the wireless interface on the Camera, other wireless devices must be compliant
with the IEEE 802.11b or IEEE 802.11g specifications. All wireless stations must use
compatible settings.
Installation
1. Mount the Camera on the supplied base and stand.
Screw the supplied antenna to the mounting point on the rear of the Camera.
Join the base, stand, and swivel connector to the camera, as shown in the diagram above.
2. Connect the LAN cable.
Connect the Camera to a 10/100BaseT hub or switch.
Figure 3: Camera Installation
2
6
Advertisement
Table of Contents
Need help?
Do you have a question about the 54 Mbps Wireless Network Camera and is the answer not in the manual?
Questions and answers