Fastening A Device Using A Vesa Adapter - Siemens SIMATIC IPC477E Operating Instructions Manual

3.2.4

Fastening a device using a VESA adapter

You can also fasten the SIMATIC IPC477E up to a display size of 24" using a 100 x 100 mm
VESA adapter.
Different models of VESA adapters are offered by third-party manufacturers.
NOTICE
Degree of protection for overall device
If you are fastening the device via a VESA adapter, degree of protection IP65 of the device is
lost.
Spray and water jets as well as penetrating substances can then damage the device.
It is not permitted to use device with VESA adapter in the scope of UL61010-2-201.
NOTICE
Dimensioning of the VESA adapter
When selecting the VESA adapter, make sure that it is designed for at least four times the
weight of the device.
The device must be mounted securely
Inadequately dimensioned fastening material may cause the device to fall down. Serious
bodily injury may result.
Make sure that fasteners are adequately dimensioned during installation of the device.
Make sure to consider the weight of the device and the forces acting on the device when
dimensioning the fasteners. This applies in particular to dynamic load of the device. All
fasteners including mounting surfaces, support arm systems, and fastening elements such
as screws must be able to carry at least four times the weight of the device.
Observe any further statutory specifications applying at the location of use of the device and
further applicable regulations with regard to the fastening of the device.
SIMATIC IPC477E
Operating Instructions, 11/2020, A5E37455003-AF
WARNING
Mounting and connecting the device
3.2 Mounting the device
45