Siemens SIMATIC IPC477E Operating Instructions Manual page 39

Positions of the mounting clips or mounting brackets for 22" devices
Attach the mounting clips or mounting brackets to the 22" device at the positions displayed
in the graphic.
NOTICE
22" devices
The mounting clip marked in red must be shifted to the left on 22" devices to account for a
cutout.
The degree of protection IP65 is not affected by the offset.
The position can be retained when using the mounting brackets.
Touch screen device
with:
•
IP65 degree of protection
The installer of the plant is responsible for proper installation of the device.
Risk of electric shock
The degree of protection cannot be guaranteed if the device is not correctly installed.
Moisture or water can penetrate and cause electric shock or plant damage.
The IP65 degree of protection is ensured for the front of the device only if you observe the
following:
• Installation with mounting clamps
• The circumferential seal is properly attached to a correctly sized cutout.
• Follow the instructions when measuring the dimensions as shown in the section
SIMATIC IPC477E
Operating Instructions, 11/2020, A5E37455003-AF
22" display
WARNING
"Preparing the mounting cutout (Page 32)".
Mounting and connecting the device
3.2 Mounting the device
Position
39