Download Print this page
Harken 1851 Instruction Sheet

Harken 1851 Instruction Sheet

Staysail furlers

Advertisement

Quick Links

1251 East Wisconsin Avenue • Pewaukee, WI 53072 U.S.A.
Web: http://www.harken.com • E-mail: harken@harken.com
Strictly follow all instructions to avoid an accident, damage to your vessel, personal
injury or death. See www.harken.com for additional safety information.
A Staysail furler makes it easy to set or strike a staysail because sail goes up and down wrapped in
a tight roll. It's easy to test the effectiveness of a staysail in marginal conditions because the crew
can set or remove sail without leaving their normal positions —they simply roll or unroll sail.
A furler makes it easier to jibe. The staysail can be rolled and dropped on deck. After boat is jibed,
the halyard can be cleared and the sail reset.
A Harken staysail furling system is designed to be left attached to sail. Store staysail by "coiling"
loosely before bagging. We suggest sheets and furling lines of different colors to minimize
confusion when setting sail.
Choosing a Staysail Furling System
Part
No.
1851
1852
1899
Maximum LP is determined by amount of line that can be wrapped on drum. If
your luff length is under 50' (15.25 m) but your LP is over 13
If your luff length is under 80' (24 m) but your LP is over 28' (8.5 m), use 1899.
Sail must be fitted with a special luff wire or rope designed for furling. This wire or rope must
transmit torque of furling unit to head of sail. Your sailmaker may need to shorten sail luff slightly to
accommodate length of drum and swivel. Some sailmakers add Velcro
tight roll during storage.
Part
No.
1851
1852
1899
Use amount shown in chart plus enough line to lead to where crew will be stationed. If you plan to
operate unit from close by add 5' (1.5 m) of line. If you plan to have a crew member furl from the
rail you may need to add 15' (4.5 m) of line or more.
I N S T R U C T I O N S H E E T
1851, 1852, 1899 Staysail Furlers
Telephone: (262) 691-3320 • Fax: (262) 691-3008
Using Harken Staysail Furler
Maximum Luff Length
ft
m
50
15.25
70
21.33
80
24
Determine Furling Line Length
Line Length (See Below)
ft
10
25
35
Maximum LP
ft
13
/
1
2
20
28
Sail Modifications
m
10
7.6
10.7
m
4
6
8.5
/
' (4 m), use 1852.
1
2
to clew of sail to hold it in a
®
Line Ø
in
5/32
1/4"
5/16
mm
4
6
8

Advertisement

loading

Summary of Contents for Harken 1851

  • Page 1 A Harken staysail furling system is designed to be left attached to sail. Store staysail by “coiling" loosely before bagging. We suggest sheets and furling lines of different colors to minimize confusion when setting sail.
  • Page 2 G Shackle Maintenance Harken equipment requires minimal maintenance, but some is required to give the best service and to comply with Harken's limited warranty. It is important to keep equipment clean by frequent flushing with fresh water. In corrosive atmospheres, stainless parts may show discoloration around holes, rivets and screws.

This manual is also suitable for:

18521899