Advertisement
PROMENTUM
COMPUTE PROCESSING MODULE
INSTALLATION GUIDE
ATCA-4500
This guide describes how to install and set up the
Promentum
ATCA-4500 compute processing module (CPM)
®
and its optional ATCA-5400 rear transition module (RTM).
Obey ESD precautions
W
!
Obey the electrostatic discharge (ESD) procedures
ARNING
described at
www.radisys.com/esd
product. Electrostatic discharge can cause permanent damage
to static-sensitive components in this product.
007-03307-0000 • August 2009
Copyright © 2009 by RadiSys Corporation. All rights reserved.
RadiSys and Promentum are registered trademarks of RadiSys Corporation.
All other trademarks, registered trademarks, service marks, and trade names are the property of their respective owners.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
®
when you install the
Important ESD procedures include:
Keep the product in its ESD shielding bag until a step
tells you to remove it.
Put on a grounded wrist strap before you move near or
touch the product.
Install the product only in a grounded work area.
Before you begin
Check all parts and accessories.
Install memory if necessary. For details, refer to the
ATCA-4500 Compute Processing Module Reference.
Included in the package
An ATCA-4500 CPM.
AMC airflow panel.
Optional components
An ATCA-5400 rear transition module (RTM).
DDR3 DIMM memory. See the ATCA-4500 Compute
Processing Module Reference for supported and
preferred DIMM combinations.
Not included in the package
An AdvancedTCA
shelf (such as an ATCA-6000 or
®
ATCA-6006).
An Advanced Mezzanine Card (AMC).
An operating system (OS) installer.
A USB CD-ROM drive or other USB storage device
from which to retrieve the OS for the initial installation.
The Promentum software distribution CD-ROM image.
Download the image at www.radisys.com/downloads.
A console serial cable (RJ-45 to DE9-S, RadiSys order
code ATCA-SERIAL-CBL). The same cable is included
in shipments of the ATCA-2210 SCM.
Note: This installation guide instructs how to load an OS
from a CD-ROM drive when the CPM is installed. If an OS
is already installed (for example, on a hard disk drive
mounted on an AMC), many of the steps can be ignored.
Advertisement
