Table of Contents
Advertisement
Quick Links
Understand manual before use. Operating AMKUS Rescue Systems without understanding
DANGER
the manual, receiving proper training, and using appropriate personal protective equipment is
a misuse of AMKUS equipment. This manual does not fully address safety. Additional safety
information is published in AMKUS Safety Manual LAA-001. Obtain safety information at
www.amkus.com/resources/information
This manual is intended for use with manuals published by manufacturers of the prime movers (engine and
pump) used in this power unit.
GH2S2-XL
Power unit with cage and hose hoop
AMKUS RESCUE SYSTEMS
www.amkus.com
©Copyright Amkus Rescue Systems, Inc. 2012- 2017
Manual: GH2S2 Series
Power Unit
EN13204 Designation: MTO
GH2S2-XLNT
Power unit with cage
4201 Montdale Drive, Valparaiso, IN 46383-4098 USA
800-592-6587 • 219-548-5000 • Fax 219-476-1669
SAFETY MANUAL for AMKUS
RESCUE SYSTEMS
Understand manual before use. Operating AMKUS Rescue Systems without understanding the
DANGER
manual, receiving proper training, and using appropriate personal protective equipment is a
misuse of AMKUS equipment. Obtain safety information at www.amkus.com/
This Safety Manual is intended to familiarize rescue workers and maintenance personnel with the safety messages of AMKUS
Rescue Systems, including powered rescue tools (rams, cutters, spreaders, combination tools), power units (electric or gasoline
driven), and powered rescue tool components (cable assemblies, hose assemblies, hose reels, etc.). The safety messages in this
publication supersede safety information appearing in AMKUS publications prior to April 2016.
This manual is intended for use with manuals published by manufacturers of prime movers (engines, electric motors, and pumps)
used in AMKUS power units.
This manual does NOT address operation or servicing of AMKUS Rescue Systems. Only competent rescue tool repair technicians
are quali ed to repair AMKUS equipment. This manual should be available to all personnel involved with AMKUS equipment.
AMKUS RESCUE SYSTEMS
4201 Montdale Drive, Valparaiso, IN 46383-4098 USA
800-592-6587 • 219-548-5000 • Fax 219-476-1669
www.amkus.com
©Copyright Amkus Rescue Systems, Inc. 2016
LAA-001 April 15, 2016 Rev00
Certifi ed Model
NFPA 1936, 2015 Edition
GH2S2-STD
Power unit with carrying handle
LAP-009 May 3, 2017 Rev05
Advertisement
Table of Contents
Related Manuals for Amkus GH2S2 Series
Summary of Contents for Amkus GH2S2 Series
- Page 1 This manual does NOT address operation or servicing of AMKUS Rescue Systems. Only competent rescue tool repair technicians are quali ed to repair AMKUS equipment. This manual should be available to all personnel involved with AMKUS equipment. AMKUS RESCUE SYSTEMS 4201 Montdale Drive, Valparaiso, IN 46383-4098 USA 800-592-6587 •...
- Page 2 CAUTION indicates a potentially hazardous situation which, if not avoided, could result in minor CAUTION or moderate injury. NOTICE is used to address practices not related to physical injury. NOTICE ©Copyright Amkus Rescue Systems, Inc. 2012- 2017 LAP-009 May 3, 2017 Rev05...
- Page 3 660 cc/min second stage Fluid Type: AMKUS MV1 Mineral Base Hydraulic Fluid. Safety Data Sheet (SDS) for AMKUS MV1 Hydraulic Fluid is available at AMKUS.com and CHEMTREC.com (For equipment stored and operated in environments below 32 deg. F (0 deg C) contact Amkus Rescue Systems for recommendation.
- Page 4 Hydraulic Fluid Hydraulic Fluid Fill Plug/Vent Cap Drain Plug (in rear) Hydraulic Fluid Pressure Ports Sight Glass Reservoir Fuel Shut Off Throttle Standard Couplings Mono Couplings Serial Number ©Copyright Amkus Rescue Systems, Inc. 2012- 2017 LAP-009 May 3, 2017 Rev05...
- Page 5 3. Next, remove the hydraulic fluid reservoir fill plug/vent cap. Fill the hydraulic fluid reservoir with approximately 2.0 gallons U.S. (7.6 liters) of AMKUS mineral base hydraulic fluid. The fluid should reach a level that fills approximately ½ of the sight gauge window.
- Page 6 7.2 SELECTOR VALVES The GH2S2 series power units are equipped with a pair of (2) two position selector valves. When facing the front of the power unit, the selector valves are in the Neutral position when perpendicular to the hose line, as shown below.
- Page 7 8.0 TROUBLE SHOOTING GUIDE Any problem not resolved by the following suggestions may require contacting your local dealer or AMKUS Rescue Systems for further guidance. Problem Solution Engine will not start or Check Honda owner’s manual. poor engine performance Check fuel level Tool lacks power Check hydraulic fluid level in power unit reservoir.
- Page 8 BEFORE BEING PLACED BACK IN SERVICE, power units must be inspected to this checklist; 1. Check to see that all markings are legible. Contact your local dealer or AMKUS Rescue Systems for replacement labels. 2. Wipe tool, hoses, fittings and couplings clean (see routine maintenance for hoses and couplings).
Need help?
Do you have a question about the GH2S2 Series and is the answer not in the manual?
Questions and answers