Mitsubishi Electric QAHV-N560YA-HPB Service Handbook page 51

[ II Restrictions ]
4 4 When connecting multiple units
To connect multiple units, configure one secondary side circuit system for each unit as shown in the figure
below. (Install a heat exchanger, flow sensor, and thermistor for each unit.)
QAHV-
N560YA-HPB
QAHV-
N560YA-HPB
(3) Optional parts
The flow sensor and thermistor in the system are sold separately.
For the pipe connection method, refer to the manuals of the optional parts (Q-1SCK).
S e c o n d a y r i c c r u t i t i k
P r a s t
Thermistor
Flow sensor
(4) Setting method for secondary side control
After configuring the secondary side control system, perform the following operation to perform the secondary side
control operation.
1. Set the digital setting item "121" to 1 (for details on the operating procedure, refer to page 28).
2. Perform a water flow rate adjustment operation (for details, refer to "Water flow rate adjustment operation (when
the secondary side control is enabled)" (page 92)).
HWE1517A
Storage tank
Q 1 - S C K
A
B
QAHV-
N560YA-HPB
QAHV-
N560YA-HPB
T h e s z i e a n
S h a p e
B C
D
C
A
- 44 -
Storage tank
d e l n g h t n o e t d a e r a p p o r i x m
S p e i c c i f t a o i n
A: 157 mm
B: 42 mm
C: 54 mm
D: 48 mm
A: 129 mm
B: R3/4
C: R3/4
Wiring length: 1.9 m
t a . e
GB