Device Status - Kaba Access manager 92 32 Technical Manual

Technical Manual
4.10.1

Device status

4.10.1.1 Connection establishment
Kaba access manager 92 32
The status of the device is indicated by the LED labeled State.
Signaling depends on the terminal software used.
The terminal software EX-AM xx.xx.xx indicates various states and processes via the
LEDs "Device status" and "exivo network".
"Device status" LED
After starting the device, the system performs several steps until it is ready for use.
They are indicated by means of the "Device status" LED as follows:
Signal
Yellow (approx. xx sec.)
Flashing in yellow (approx. xx sec.)
Red (approx. xx sec.)
Green, then flashing in green
Status and error states after system start
Signal
Green
Red/flashing in green
Flashing in yellow
Flashing in red
"exivo network" LED
Signal
Lit in red
Flashing in yellow
Blinking in green
Lit in green
04045524 - 08/2016
Design and function
Meaning
The operating system is started
Waits for possible key actuation (cold
start)
Waits for possible key actuation (default
IP)
The terminal software is started
Meaning
Terminal software was started success-
fully
1-click installation active
The device is waiting for registration by
the Internet platform
Terminal software was not started
Terminal software could not be started
Reason:
Meaning
No connection with the exivo platform
Connection with the exivo platform has
been established
The device has been assigned to a sys-
tem
The device has been successfully as-
signed to a door
21