Applications; Im/P2P Application Filtering - TRENDnet TWG-431BR User Manual

TRENDnet User's Guide

IM/P2P application filtering

Advanced > Access Control
You can deny access to a list of predefined IM/P2P applications outbound and filter by
MAC and/or IP address. You can check the current MAC addresses of devices connected
to your router under System > VLAN Setup > DHCP Server under the DHCP leases
section. You can also lock the IP address assigned to specific devices connected to your
router by adding static DHCP leases or
be used to filter other outbound traffic by IP address, URL/keyword filter, and IM/P2P

applications.

1. Log into your router management page (see
on page 7).
2. Click on Advanced and click on Access Control.
3. Review the settings below.
•
Active – Select Enable to enable the access control rule.
•
Comment – Enter the name or description for the access control rule.
•
Protocol – Click the drop-down list to select the protocol for the service to
filter: ANY, TCP, UDP, ICMP, Content Filter, Domain Filter, IP P2P, or IM. Select
IP P2P or IM to select from a list of predefined applications.
•
Schedule – Allows you to select a schedule when the access control rule should
be enabled or disabled.
•
MAC Address –Enter the MAC address you would like to filter or deny traffic
and click Add to add to the list. (e.g. a1:b2:c3:d4:e5:f6)
Note: You can filter by MAC address or IP address.
© Copyright 2019 TRENDnet. All Rights Reserved.
reservations. The access control section can also
"Access your router management page"
•
Local IP Address – Enter the IP address range to apply the access control rule.
(ex.: 192.168.10.20 – 192.168.10.30)
•
Local Port – Enter the source/local port. (Optional for IP P2P/IM)
•
Comment – Enter the name or description for the access control rule.
•
Destination IP Address – Enter the destination IP address range for the access
control rule. If left empty, this means any. (ex.: 10.10.10.20 – 10.10.10.30)
•
Destination Port – Enter the destination port. (Optional for IP P2P/IM)
•
Interface – Click the drop-down to select the local interface to apply the access
control rule.
•
IP/P2P or IM Setup – Select from the list of predefined P2P/IM applications to
apply the access control rule.
TWG-431BR
32