Setting Up The L2Tp Vpn Server With Ipsec Encryption (Psk) - TRENDnet TWG-431BR User Manual

TRENDnet User's Guide

Setting up the L2TP VPN server with IPsec encryption (PSK)

1. Log into your router management page (see
on page 7).
2. Click on System and click L2TP Server Setup.
3. For the Mode, select the Enable option to enable the L2TP server.
4. In the Local IP Address field, enter an IP address other than the LAN IP address.
(Default LAN IP: 192.168.10.1) (e.g. 192.168.80.1)
Note: Entering an IP address different from the LAN IP address as the Local IP of the L2TP
server ensures your L2TP VPN clients are able to access the Internet and the router LAN
network via full tunneling. If the LAN IP address is entered, L2TP VPN clients will be
allowed to access router LAN and not the Internet.
© Copyright 2019 TRENDnet. All Rights Reserved.
"Access your router management page"
5. In the Remote Start/End IP Address fields, enter an IP address range (within the same
Local IP Address subnet range) to assign to L2TP VPN clients.
In this example, we assigned 192.168.80.1 as the Local IP Address for the L2TP server so
we will assign a range such as 192.168.80.10-192.168.80.20.
6. Under L2TP Over IPSec Settings, for the Mode, select Enable.
7. Enter the Pre-shared Key for IPsec encryption.
8. Click the WAN ID drop-down list to select the correct WAN interface for the L2TP over
IPsec server.
9. Click Save at the bottom.
10. Click on System, click on PPTP/L2TP Account Setup, and click Create Account.
TWG-431BR
49