Table of Contents
Advertisement
Rear Panel
Power Supplies
Disable Power
Alarm Button
Getting Started
Before you turn on the storage enclosure do the following:
1.
Make sure the power voltage switch (115 volts or 230 volts) is set
correctly to the right voltage before turning on the power.
2.
Install the RS700 into the Rack (for RM101 and RM102 models only).
3.
Install the SCA hard disk drives into the drive trays and check the hard
disk drive ID numbers.
4.
Lock all drive trays.
6
Hot-swap
Redundant
(red)
COM Ports
SCSI Expansion
slots
Redundant Fans
Cooling Fan
Power Connector
Advertisement
Table of Contents
