Table of Contents
Advertisement
SAFETY
This document provides technical guidance on the installation and operation of the
MagIQtouch BMS Industrial Controller MS1.
EMPLOYER AND EMPLOYEE RESPONSIBILITIES
Please read this manual carefully. Your failure to do so could result in injury to you or
damage to the cooler and property.
The installation and maintenance of coolers at height has the potential to create
Occupational Health and Safety issues for those involved. Installers are advised to
ensure they are familiar with Local Acts, Regulations and Standards, which may offer
practical guidance on health and safety issues. Compliance with these regulations will
require appropriate work practices, equipment, training and qualifications of workers.
INSTALLER AND MAINTENANCE CONTRACTORS – RISK ASSESSMENT
Seeley International provides the following information as a guide to contractors and
employees to assist in minimising risk whilst working at height.
A risk assessment of all hazardous tasks is required under legislation. A risk assessment
is an essential element that should be conducted before the commencement of work, to
identify and eliminate the risk of falls or to minimise these risks by implementing control
measures. There is no need for this to be a complicated process, it just is a matter
of looking at the job to be done and considering what action(s) are necessary so the
person doing the job does not injure themselves.
This should be considered in terms of:
What are the chances of an incident happening?
What could the possible consequence be?
What can you do to reduce, or better still, completely get rid of the risk?
WARNING!
The MagIQtouch BMS Controller requires an approved Safety Extra Low Voltage (SELV)
12Vdc power supply to be connected to the power supply input of the MagIQtouch BMS
controller. The outputs from the controller require this approved SELV power supply in
order to maintain the SELV circuit. Except for the RJ 6 way connection to the cooler,
other inputs and outputs should only be connected to the SELV circuit of the building
management system. Interconnection wiring between the MagIQtouch BMS controller
and the building management system shall be separated by reinforced insulation to any
live parts. Installation and location of the BMS controller shall be sufficiently separated
from live parts to comply with reinforced insulation.
This MagIQtouch BMS Industrial Controller is to be installed indoors only, installation
shall only be performed by suitably trained and qualified personnel, in accordance with
local and national wiring rules.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance. If any cables are damaged, they shall be replaced by the
manufacturer or its service agent or similarly qualified person in order to avoid a hazard.
Stranded conductors shall not be consolidated by lead-tin soldering where they are
subject to contact pressure, i.e. on terminal block.
MAGIQTOUCH BMS INDUSTRIAL CONTROLLER - MANUAL |
3
Advertisement
Table of Contents
