Table of Contents
Advertisement
DIAGNOSTIC LED's
PWR / ERROR CODE LED
Diagnostic and cooler operating information can be viewed from the MagIQtouch BMS
Industrial Controller via the Error Code LED's.
When power is applied to the RJ port of the BMS module MS1 and no error is detected
the LED will illuminate continuously.
If an error is detected by the controller, the 'ERROR STATUS' LED will start illuminating
on the front panel. The type of error will be indicated by the sequence of flashes
highlighted on 'ERROR CODE' LED.
Errors can be cleared by applying a low level and then high level on the 'SYSTEM ON
INPUT'.
Error codes can be cleared using the "RESET" button on the front of the controller.
•
OFF: BMS Module Off (no power received from Cooler on RJ port).
•
ON: BMS is operational (Communication to Cooler and Wall Control OK, Cooler
has no faults).
•
Flashing: cooler has a fault, number of flashes corresponds to Fault Code (i.e.: 2
flashes => FC02).
NOTE: Error Codes can vary between products. Refer to the cooler Installation Manual.
BMS INDUSTRIAL CONTROLLER M1
BMS INDUSTRIAL CONTROLLER MS1
PWR /
ERROR CODE
Part No.
Error
Fault Code #1
1 Flash
Communication Failure.
Fault Code #2
2 Flashes
Failure to Detect Water at Probes.
Fault Code #4
4 Flashes
ILL2486-A
Failure to Clear Probes during drain.
Fault Code #7
7 Flashes
Motor Fault
MAGIQTOUCH BMS INDUSTRIAL CONTROLLER - MANUAL |
ILL2108-A
17
Advertisement
Table of Contents
