Table of Contents
Advertisement
ELECTRICAL INSTALLATION cont.
Master or Slave Mode
The BMS MS1 controller can be used as either a 'Master' or 'Slave' Controller.
Master Mode
The BMS MS1 is controlled with BMS signals only and no MagIQtouch wall
controller can be used. Only 1 x BMS MS1 per 1 x cooler can be used in this
configuration.
Slave Mode
The BMS MS1 controller is a 'Slave' to the MagIQtouch wall controller. When
the BMS MS1 'ON/OFF' signal is 'ON' the BMS MS1 controller takes control of
the MagIQtouch wall control remotely. During remote access the MagIQtouch
wall control will display "BMS CONTROL" and will not be operational.
Activating Master or Slave Mode
Remove the front cover of the BMS MS1 controller and set the dip switch to the
requirements of your installation.
MAGIQTOUCH BMS INDUSTRIAL CONTROLLER - MANUAL |
Master Mode
Slave Mode
ILL2480-A
11
Advertisement
Table of Contents
