Sony HCD-M80 Service Manual page 2

HCD-M80
General
Power requirements
Saudi Arabian models: 120 – 127 V or
220 – 240 V AC,
50/60 Hz
Adjustable with voltage
selector
Thailand model: 220 V AC, 50/60 Hz
Other models: 110 – 120 V or
220 – 240 V AC,
50/60 Hz
Adjustable with voltage
selector
Power consumption See the nameplate
Dimensions (w/h/d) incl. projecting parts and controls
Approx. 159 × 217 ×
335 mm
Mass Approx. 5.2 kg
Design and specifications are subject to change
without notice.
2
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
The following caution label is located inside the apparatus.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED
LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
This appliance is classified
as a CLASS 1 LASER
product. This label is
located on the rear exterior.