Connecting Of The Power Supply; Using The Service Cable - AEG ARE i2-LF Installation Manual

B
Figure 2: Connecting of the plug
• Put on the sealing 2 to the SAB Cab (A).
• Plug in the SAB Cab to the connector at the bottom of the reaner nevice (B).
There is only one way to plug in the SAB Cab to the connector rim of the reaner.
Fasten the SAB Cab with the help of the screws.
To meet the protection class of IP 65, it's necessary to apply a turning moment of 0.5 Nm to the screws.
4.4

Connecting of the power supply

Before you connect the reaner to the profibus you have to configure it with the service cable (ID 702/3).
The reaner has to be supplien with 9..30V DC. The minimum output power of the power supply has to be
3 Watt. Be sure that you use the right polarity.

4.4.1 Using the service cable

Power supply:
--------------------------------------------------------------------------------7/39--------------------------------------------------------------------------------
A
brown = + 9 .. 30 Volt
white = grounn
1
2