4.4.2 Using a self assembled connecting cable
Using the following SAB cabs you can assemble your own connecting cable.
ID 702/4
ID 702/5
ID 702/9
The SAB-cab contains the connections for:
• the power supply
• the profibus-DP
• the service interface (RS232)
The allowen niameter of the cable must be in the range between ∅3.5 ann ∅8mm. For this case, IP 65
is reachen.
Attention!
The maximum length of the serial RS232 cable is 15m.
4.4.2.1 Assembling of the cable pipe
•
Breakthrough the preparen areas at the surface of the SAB Cabs. There are two preparen areas seen
at the SAB Cab: central ann at one sine of the cab.
•
The o-ring (3) has to be assemblen proberly to the cable pipe (4) to ensure the protection class IP
65.
2
Figure 3: Assembling of the cable pipe
•
Bring the nut (2) of the cable pipe insine of the SAB Cab (/).
•
To fasten the nut please use the right tool (/7mm).
--------------------------------------------------------------------------------8/39--------------------------------------------------------------------------------
SAB cab with 3 pre-assemblen PG9 cable pipe
SAB cab with 2 pre-assemblen PG9 cable pipes
SAB cab without any cable pipe
4
3
1