Table of Contents
Advertisement
B
Figure 1: Connecting of the plug
Put on the sealing 2 to the SAB Cab (A).
Plug in the SAB Cab to the connector at the bottom of the reader device (B).
There is only one way to plug in the SAB Cab to the connector rim of the reader.
Fasten the SAB Cab with the help of the screws.
To meet the protection class of IP 65, it's necessary to apply a turning moment of 0.5 Nm to the screws.
3.3
Connecting of the power supply cable
The reader has to be supplied with 9..30V DC. The minimum output power of the power supply has to be
1.2 Watt. Be sure that you use the right polarity.
3.3.1 Using the pc connection cable ID 70213
Power supply:
--------------------------------------------------------------------------------7/50--------------------------------------------------------------------------------
A
brown =
+ 9 .. 30 Volt
white =
ground
1
2
Advertisement
Table of Contents
