Step 1 - Prepare Ceiling - Bestop HOSS HARDTOP HOIST Assembly Instructions, Use & Care Manual And Warranty

1
Prepare ceiling
□ Position the paper motor mounting template in the installation location and mark with a pencil the six spots where the
lags bolts will be fastened.
□ It is very important that the wood screws are fastened to the center of the joists. Use the hole saw drill bit (R) or cut away
the drywall with a utility knife to obtain an unobstructed view of the width of the joists so the exact center can easily be
determined (covered ceilings only). It may be necessary to again use the motor mounting template and a pencil to mark
where the wood screws are to be fastened.
MAKE SURE YOU MOUNT TO THE CENTER
OF EACH JOIST TO SECURE YOUR HOSS
HARDTOP HOIST PROPERLY
16 IN. JOISTS
FAILURE TO PROPERLY INSTALL YOUR MOUNTING PLATE TO
THE CENTER OF YOUR JOISTS WILL CAUSE YOUR SPACER BAR
TO BE OFFSET FROM CENTER OF JOISTS AND MAY CAUSE
YOUR HOSS HARDTOP HOIST TO FALL FROM CEILING.
P7 – 4282001 Rev. A 0720
Installation
HOSS HARDTOP HOIST
MARK THESE SIX HOLES FOR 24 IN. JOIST CENTERS
MARK THESE SIX HOLES FOR 16 IN. JOIST CENTERS
Installation instructions – HOSS HARDTOP HOIST
ALL JEEP® WRANGLER
AND GLADIATOR HARDTOP
Part Number 42820-01
EXAMPLE OF BAD ALIGNMENT
Vehicule application:
©BESTOP 2020, inc.