Table of Contents
Advertisement
4
Connect and install the spacer channel pulley bar
□ Press the spacer channel bar flush with the ceiling and mark ceiling with a pencil where a lag bolt will be used to attach the bar to the
joist.
– Perpendicular joist installation (option A or B on page 6). Make a mark at either the 16 in. hole or 24 in. hole depending on your joist
spacing. Remove the spacer channel bar.
– Parallel joist installation. You can install a lag bolt before and after the pulley for extra support (option C or D on page 6).
Remove the spacer channel bar.
□ It is very important that the lag bolt is fastened to the center of the joist. Use the hole saw drill bit (R) or cut away the drywall with a
utility knife to obtain an unobstructed view of the width of the joist so the exact center can easily be determined. It may be necessary
to reposition the spacer channel bar and mark with a pencil where the lag bolt is to be fastened.
□ Using a power drill with a 1/8 in. drill (U) bit attached, drill a pilot hole into the center of the joist.
□ Place the spacer channel bar over the motor plate tab and screw together using supplied bolt.
□ Tighten with a ratchet or adjustable wrench until the spacer channel bar is securely fastened to the motor hoist.
□ Place a lag bolt(s) (K) and using the ratchet fasten the bolt(s) into the joist(s) until the spacer channel bar is securely fastened.
P11 – 4282001 Rev. A 0720
Installation
HOSS HARDTOP HOIST
16"
Installation instructions – HOSS HARDTOP HOIST
Vehicule application:
ALL JEEP® WRANGLER
AND GLADIATOR HARDTOP
Part Number 42820-01
©BESTOP 2020, inc.
Advertisement
Table of Contents
