Table of Contents
Advertisement
13
Install the freedom hook to the wall
□ Locate studs and mount to wall using bolt (K).
2 Holes to mount
hook to studs
Operating instructions
TO RAISE OR LOWER THE HOIST:
□ Do not stand under the hoist
□ Press and hold the rocker switch in the direction you want the
hook bar to travel.
□ Release the switch when the desired location is reached.
□ Operator must let the motor stop for 8 minutes after
continuously working for 2 minutes cool after raising or
lowering the lift.
P18 – 4282001 Rev. A 0720
Installation
HOSS HARDTOP HOIST
Installation instructions – HOSS HARDTOP HOIST
Maintenance
□ Check to be sure the motor is properly attached to its
mounting plate. Make sure the bolts are tight.
□ Periodically check the condition of the electrical cords, plugs
and controls.
□ Periodically check straps for slippage or excessive wear.
Specifications
□ Model: 42820-01
□ Load capacity: 220 lb
□ Lifting Height: 120 in.
□ Lifting speed: 22 ft./min
□ Strap width: 1.25 in.
□ Voltage: 120 V / 60 HZ / 2.35 amps
□ Motor: 280 W 3 / 5 HP
□ Capacitor: 35uF
□ Duty cycle: 2.5 min On, 7.5min Off
Vehicule application:
ALL JEEP® WRANGLER
AND GLADIATOR HARDTOP
Part Number 42820-01
x 2
©BESTOP 2020, inc.
Advertisement
Table of Contents
