Table of Contents
Advertisement
4-9.
AU-358 Board
Preparation
1.
Remove the top cover. (Refer
2.
Remove the front assembly. (Refer to
Procedure
1.
Disconnect the harness from the connector (CN003) on the AU-358 board.
2.
Disconnect the flexible flat cable from the connector (CN001) on the AU-358 board.
3.
Remove the three screws to detach the AU-358 board.
4.
Remove the rotary encoder knob.
5.
Remove the two cushions.
6.
Install the removed parts by reversing the steps of removal.
HXCU-TX70
to"4-2. Top
Cover")
"4-3. Front
Assembly")
Cushions
Rotary encoder knob
CN001
Flexible flat cable
AU-358 board
PSW3 x 6
Harness
CN003
4-13
Hide quick links:
Advertisement
Table of Contents
