Table of Contents
Advertisement
4-8.
FL-378 Board
Preparation
1.
Remove the top cover. (Refer to
2.
Remove the DM shield plate and the FL cover. (Refer to
Procedure
1.
Disconnect the harness from the connector (CN003) on the FL-378 board.
2.
Disconnect the coaxial cable from the connector (CN002) on the FL-378 board.
3.
Remove the three screws to detach the FL-378 board.
Note
Be sure to hold the plug when disconnecting the coaxial cable. Do not pull the cable.
OK
Hold the plug to remove.
FL-378 board
Note
Hold the plug of the coaxial cable, and connect it perpendicularly to the connector. Push the plug into the connector
while turning it clockwise and counterclockwise several times.
4.
Install the removed parts by reversing the steps of removal.
HXCU-TX70
"4-2. Top
Cover")
"4-7. TRIAX Connector
NG
Do not attempt to remove
by pulling the cable.
PSW
CN002
3 x 6
CN003
Assembly")
Coaxial cable
Note for installation
Hold the plug to connect.
Harness
Connecting
connector
4-12
Hide quick links:
Advertisement
Table of Contents
