Tekno Point PICCOLO Mono Use And Installation Manual page 39

USER GUIDE INDOOR UNIT
3. USER GUIDE
INDOOR UNIT
INDOOR UNIT
panel
filter horizontal
3.1 BATTERY INSTALLATION
1. Press the back of the remote at the point indicated by the
symbol slide the cover in the direction of the arrow.
2. Insert two 1.5V AAA batteries, and make sure that the
polarity is correct. Re-insert the cover.
3.2 USER GUIDE
1. After powering up the device, press the "ON / OFF" button
on the remote control to turn them on the device.
2. Press the "MODE" button to select the desired
operating mode: Auto (Auto Preset), Cool (cooling), Dry
(dehumidification), Fan (ventilation), Heat (heat pump).
3. Press the + or - buttons to select the desired temperature.
(Can not be selected in AUTO mode).
While using the remote control aim it in the direction
Inner Unity.
The distance between the remote control and the
receiver must not be greater than 8 meters, and there
must be no obstacles.
The infrared signal could suffer interference from the
reactor of fluorescent lamps or WI-FI sources. In these
cases it is recommended that the distance between the
remote control Indoor Unit.
inlet air
outlet emergency
flap air switch
REMOTE CONTROL
display
3. After powering up the device, press the "ON / OFF" button
on the remote control to turn them on the device.
4. Press the "FAN" button to select the desired fan speed:
Auto, fan1, fan2, Fan3, fan4, fan5, InfinteSpeed.
5. Press the buttons to select the direction of the air
flow.
Replace the old batteries with two new of the same
type, and dispose of according to current legislation.
In the event of prolonged disuse of the remote control
it is advisable to remove the batteries.
39
U INS
INSTALLATION MANUAL PICCOLO
CAT
7