Installing A Cpu Module - Motorola CompactPCI CPX2000 Series Installation And Reference Manual

Installing the CPX2000 Series System and Field Replaceable Units
3

Installing a CPU module

3-16
6. Pull the module from the chassis.
Step 4
Use this procedure to install a CPU module into the chassis.
1. Align the module with the upper and lower card guides in the
chassis and make sure the ejection levers are open. Refer to the
figure on page 3-17.
2. Carefully install the top and bottom edge of the module in the upper
and lower card guides of the chassis and slide the module into the
chassis until you feel resistance (approximately 1/4 inch short of full
insertion).
3. Press the ejection levers inward simultaneously until they lock into
their slots.
Step 5
Literature Center Web Site
Step 6
2244 9805 (i)