Before Installing the CPX2000 Series Chassis
2
!
Warning
Safety and Regulatory Compliance
Tools You Need
2-2
Turn system power off before you perform these procedures.
Failure to turn the power off before opening the chassis can
result in personal injury or equipment damage. Hazardous
voltage, current and energy levels are present in this product.
Power switch terminals can have hazardous voltages present
even when the power switch is off. Do not operate the system
with the covers removed.
The CompactPCI CPX2000 Series system complies with the safety and
regulatory standards applicable to component-level equipment. It is
possible, however, to use this product with other components that produce
a system not in compliance with system guidelines. Since Motorola cannot
anticipate what equipment may be used with this enclosure or how it may
be used, the responsibility for designing a system that conforms overall to
CSA (C/US)/VDE safety requirements and EMI/RFI emission limits rests
entirely with the system integrator and installer.
You need the following tools to remove and install components of a
CPX2000 Series system:
number 1, Phillips head screwdriver, four inch shaft
number 1, Phillips head screwdriver (right angle)
slotted head screwdriver
Literature Center Web Site