Limited Warranty - Zoeller QWIK JON 100 Installation Instructions Manual

Table of Contents

Advertisement

Manufacturer warrants, to the purchaser and subsequent owner
during the warranty period, every new product to be free from
defects in material and workmanship under normal use and
service, when properly used and maintained, for a period of
one year from date of purchase by the end user, or 18 months
from date of original manufacture of the product, whichever
comes first. Parts that fail within the warranty period, one year
from date of purchase by the end user, or 18 months from the
date of original manufacture of the product, whichever comes
first, that inspections determine to be defective in material or
workmanship, will be repaired, replaced or remanufactured at
Manufacturer's option, provided however, that by so doing we
will not be obligated to replace an entire assembly, the entire
mechanism or the complete unit. No allowance will be made
for shipping charges, damages, labor or other charges that may
occur due to product failure, repair or replacement.
This warranty does not apply to and there shall be no warranty
for any material or product that has been disassembled
without prior approval of Manufacturer, subjected to misuse,
misapplication, neglect, alteration, accident or uncontrollable act
of nature; that has not been installed, operated or maintained
in accordance with Manufacturer's installation instructions;
that has been exposed to outside substances including but
not limited to the following: sand, gravel, cement, mud, tar,
hydrocarbons, hydrocarbon derivatives (oil, gasoline, solvents,
etc.), or other abrasive or corrosive substances, wash towels
HELPFUL HINTS FOR EASY INSTALL
1. Read all instructions before beginning installation.
2. Be sure the installation has a minimum of 5 feet vertical
head.
3. Be sure the floor is level within 1/8" for the length and width
of the tank.
4. Install 2" discharge pipe seal with flange side of seal on
inside of lid. See Figure 7.2 on page 6. (Models 100 & 102
only)
5. Use soapy water to lubricate all seals to aid installation.
6. Install rubber coupling/union in vent line to aid disassembly.
See Figure 7.4 on page 6.
7. Test unit before mounting toilet. Check On/Off levels per
step 6 of instructions.
8. Do not over torque toilet mounting screws.
9. Do not use an automatic plumbing vent device.
10. Obtain model number and date code, and record information
in the space provided on the front of this manual. Refer to
this information when calling factory.

LIMITED WARRANTY

or feminine sanitary products, etc. in all pumping applications.
The warranty set out in the paragraph above is in lieu of all
other warranties expressed or implied; and we do not authorize
any representative or other person to assume for us any other
liability in connection with our products.
Contact Manufacturer at, 3649 Cane Run Road, Louisville,
Kentucky 40211, Attention: Customer Support Department to
obtain any needed repair or replacement of part(s) or additional
information pertaining to our warranty.
MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR
SPECIAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES
OR BREACH OF EXPRESSED OR IMPLIED WARRANTY;
AND ANY IMPLIED WARRANTY OF FITNESS FOR A
PARTICULAR PURPOSE AND OF MERCHANTABILITY
SHALL BE LIMITED TO THE DURATION OF THE
EXPRESSED WARRANTY.
Some states do not allow limitations on the duration of an implied
warranty, so the above limitation may not apply to you. Some
states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion
may not apply to you.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.
1. DO read all installation material with the pump and tank.
2. DO inspect unit for any visible damage caused by shipping.
3. DO clean all visible debris from the tank.
4. DO always disconnect pump from power source before
5. DO install a check valve and a union in the discharge line. DO
6. DO test pump immediately after installation to be sure that
7. DO review all applicable local and national codes and verify
8. We DO NOT recommend this product be connected to utili-
© Copyright 2013 Zoeller Co. All rights reserved.
2
DO'S AND DON'T'S FOR INSTALL
Contact dealer if unit appears to be damaged.
handling. DO always connect to a separately protected and
properly grounded ground fault protected circuit. DO NOT
ever cut, splice or damage power cord. DO NOT carry or
lift pump by its power cord. DO NOT use an extension cord
with a sewage pump.
NOT use a discharge pipe smaller than the pump discharge
size.
the system is working properly.
that the installation conforms to each of them.
ties other than those found in a normal bathroom applica-
tion. Washing machines and dishwashers are examples of
equipment that we Do NOT recommend.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents