Ferroli Napoli 600 Instructions For Use & Instalation page 58

N A P O L I
When the emitter is locked, the padlock icon will appear in the upper area of the screen. It is
possible to lock the emitter in all modes, even Standby mode.
5.9 INTERNAL PARAMETERS CONFIGURATION
There are two user configurable internal parameters in the emitter. By design they are not meant
to be changed often.
To access the parameter selection menu, touch and hold the OK and Mode keys for 5 seconds
until the menu appears on the display.
The first line shows the software version of the emitter; this information may
be required if you need to contact technical support regarding your emitter. It
is not adjustable by the user and is only shown for information.
WARNING: The last line is an internal production parameter. Under no
circumstances may it be modified by the user.
Param. 1: Temperature Offset
The first parameter on the menu is the probe correction setting. Adjustment of this value is used
in case the temperature measurement shown on the display of the emitter is very different from
temperature measurements in the space.
For example, the emitter stops heating before the room temperature reaches the selected set
point temperature of 21 °C; the emitter stops when the room temperature is only showing 19 °C.
As the room temperature remains 2 °C below the set point, a value of -2.0 should be entered to
the incorrect measurement shown on the display.
The probe correction value is set using the p and q keys, in steps of 0.1 °C. The value can range
from -5 °C to + 5 °C. Confirm the set point by touching OK. The menu will then move to the second
parameter.
Param. 2: Easy Mode
The second parameter on the menu allows the selection of an "Easy Control" way to control the
emitter.
1P: 1P is the default value (Normal Mode), and will allow full control over all the features of the
emitter. All the functions detailed in this manual are available in 1P.
2P: 2P will enable EASY MODE (page 59); this is the easiest way to control the emitter.
Select either 1P or 2P using the p and q keys and confirm by touching OK. The menu will then
move to the last parameter.
58
A73023140
EN