Ferroli Napoli 600 Instructions For Use & Instalation page 46

N A P O L I
N A P O L I SMART DRY ELECTRIC THERMAL EMITTER
1. PRESENTATION
Dear customer
Thank you for choosing NAPOLI electric thermal emitters, with their sophisticated design, state-
of-the-art electronics and high reliability (TRIAC), smart control for maximum efficiency and high
build quality. They comply with the Ecodesign Directive and are designed and manufactured in
Spain.
The NAPOLI thermal emitters of FERROLI, as well as all their materials and components, have
undergone rigorous quality control tests.
Before switching the emitter on, you must carefully read these instructions which will help you
to ensure correct operation of the device with maximum performance and complete satisfaction.
Keep them close by in case of any doubts.
2. LOCATION
The ideal place to install the emitter is as close as possible to the coldest wall in the room. It is not
recommended to install the emitter on external walls without any insulation, however, in this case,
the section of wall behind the thermal emitter must be insulated.
In bathrooms, the electric thermal emitter must be installed outside the protective area, according
to the regulations in force (zone 3 in the picture).
Classification of the bathroom zones
46
A73023140
EN