Ferroli Napoli 600 Instructions For Use & Instalation page 54

N A P O L I
5.3.5.2 Maximum brightness Time
This menu sets the time (in seconds) that the emitter screen is at 100 % brightness, from the time
that the last key is touched, before going to rest.
The time value can be changed between 1 and 240 seconds. The time can be adjusted using the
p and q keys; if the keys are held then the time changes faster. Confirm the selection by touching
the OK key; the emitter will then return to the Configuration screen.
5.3.5.3 Setting the time
This menu is used to initially set the time and day, and
also to change the time if required, for example, during
daylight saving.
Use the p and q keys to select either the day of the
week, or (if the day is correct) the time to be modified.
Touch OK to enter the desired section to change.
Select the day with the p and q keys; you can choose from Monday to Sunday and confirm the
correct day by touching OK.
When setting the time, the setting starts with the hour; select from 00 to 23 using the p and q
keys. Once the hour is correct, touch the OK key; the emitter will change to set the minutes,
selecting from 00 to 59 using the p and q keys and confirm by touching OK.
To go back to the Configuration
screen, touch the Mode key at any
time.
Daylight saving time will need to
be manually changed.
When the button cell battery life ends (see page 50), after a power failure or disconnection from
the mains of more than one minute the emitter will request the user to set the hour/day, as the
system clock is reset to Monday 00:00.
The battery icon will flash until the hour/day is set. After 30 seconds the emi-
tter will choose Monday and 00:00 as the day and time and will return to the
last used mode of operation.
The emitter will request the time to be set each time there is a power discon-
nection of more than one minute or until the button cell is replaced.
5.3.5.4 Open Windows
This menu enables/disables the Open Windows function (see page 57 of this manual). Se-
lect ON/OFF with the p and q keys and confirm with the OK key; the emitter will return to the
Configuration screen after the selection is made.
5.3.5.5 Adaptive start control
This menu enables/disables the Adaptive start control function (see page 57 of this manual).
Select ON/OFF with the p and q keys and confirm with the OK key; the emitter will return to the
Configuration screen after the selection is made.
54
A73023140
EN