Samsung WD8 K64 Series Service Manual page 31

Part name
DD 1.Unfasten the 4 screws that hold
MOTOR
2. After removing the back cover,
3. Remove the M19 nut washer and
4. Unfasten the six (6) M10 screws.
5. Remove the motor wire and hall
√Check Points for Troubleshooting
1. Check whether there are any foreign substances between the rotor and
2. Check whether the motor power wires (blue, while, red) are connected
3. Check whether the hall sensor wire is connected correctly.
- Connect the motor power wires in the order blue, white and red, starting
WD6500K_7-8-9-11kg_1400rpm-SM.indb 29
Description
the back cover in place. Remove
the back cover by sliding it down.
unfasten the M19 nut that holds
the motor in place.
Do not try to unfasten the nut
by inserting a screw driver into the
motor. This may cause a motor
malfunction.
then remove the rotor.
Remove the assy bracket motor.
Remove the stator.
sensor while holding down the
navel of the housing.
the stator.
correctly.
from the furthest right. Check whether each voltage between blue and
white, white and red, red and blue is 15Ω.
Figure
MoToR WIRE
HALL SENSoR
Disassembly and Reassembly_29
2018/11/9 9:53:26