Samsung WD8 K64 Series Service Manual page 27

Part name
Removing 3. Remove the screw.
the Duct
(Replacing
the Dry
Motor)
√Check Points for Troubleshooting
1. Revolve the dry motor manually and check whether Spin the dry motor
2. Measure the internal resistance (between the white and blue wire termi-
→ several Ω: short-circuited, ∞: disconnected
Removing
1.Remove the connector.
Remove the jacks connected to
the Duct
(THERMO-
STAT)
√Check Points for Troubleshooting
●
→ If th e stud is raised due to overheating and it is pressed, it will be re-
Removing 1. Remove the two (2) screws
the Duct
(THERMIS-
TOR)
WD6500K_7-8-9-11kg_1400rpm-SM.indb 25
Description
manually and check that it rotates freely.
nals)
the thermostat and remove the
four (4) screws, as shown in the
figure.
Measure the resistance between both ends of the thermostat: 0 Ω
turned to the original position with a 'snapping' sound.
connected to the dry duct and
remove the white thermistor.
Figure
Disassembly and Reassembly_25
2018/11/9 9:53:18