Parkside PWSA 12-LI A1 Translation Of The Original Instructions page 84

GB MT
le, use a residual current de-
vice (RCD) protected supply.
Use of an RCD reduces the
risk of electric shock. Use a
circuit breaker with a current
limit of 30 mA or less.
Personal safety:
CAUTION! The following
states how to avoid acci-
dents and injuries:
• Stay alert, watch what you
are doing and use common
sense when operating a po-
wer tool. Do not use a power
tool while you are tired or
under the influence of drugs,
alcohol or medication. A mo-
ment of inattention white ope-
rating power tools may result
in serious personal injury.
• Use personal protective equip-
ment. Always wear eye pro-
tection. Protective equipment
such as dust mask, non-skid
safety shoes, hard hat, or hea-
ring protection used for appro-
priate conditions will reduce
personal injuries.
• Prevent unintentional starting.
Ensure the switch is in the off-
position before connecting to
power source and/or battery
pack, picking up or carrying
the tool. Carrying power
tools with your finger on the
switch or energising power
tools that have the switch on
invites accidents.
• Remove any adjusting key
or wrench before turning the
84
power tool on. A wrench or a
key left attached to a rotating
part of the power tool may
result in personal injury.
• Do not overreach. Keep pro-
per footing and balance at
all times. This enables better
control of the power tool in
unexpected situations.
• Dress properly. Do not
wear loose clothing or
jewellery. Keep your
hair, clothing and gloves
away from moving
parts. Loose clothes, jewelle-
ry or long hair can be caught
in moving parts.
• If devices are provided for the
connection of dust extraction
and collection facilities, en-
sure these are connected and
properly used. Use of dust
collection can reduce dust-
related hazards.
Power tool use and care :
• Do not force the power tool.
Use the correct power tool for
your application. The correct
power tool will do the job
better and safer at the rate
for which it was designed.
• Do not use the power tool if
the switch does not turn it on
and off. Any power tool that
cannot be controlled with the
switch is dangerous and must
be repaired.
• Disconnect the plug from the
power source and/or the bat-
tery pack from the power tool
before making any adjust