Post-Installation Instructions - Acer AcerPower 6200 User Manual

1.10

Post-installation Instructions

Observe the following after installing a system component:
1. See to it that the components are installed according to the step-
by-step instructions in their respective sections.
2. Make sure you have set all the required jumpers. See section
1.3.2 for the correct jumper settings.
3. Replace any expansion boards or peripherals that you removed
earlier.
4. Replace the system cover.
5. Connect the necessary cables and turn on the system.
1.11 USB
USB is a new serial bus design that is capable of cascading
low-/medium-speed peripherals (less than 12 Mbps) such as
keyboard, mouse, joystick, scanner, printer and modem/ISDN. With
USB, complex cable connections at the back panel of your PC can be
eliminated.
See Figure 1-1 for the location of the USB interface on the system
board.
System Board 1-23