Reconfiguring The System; Ide Hard Disk Support - Acer AcerPower 6200 User Manual

1.7.4

Reconfiguring the System

You must enter Setup after installing or removing SIMMs to
reconfigure the system.
Follow these steps to reconfigure the system:
1. Turn on the system.
indicating that the total memory does not match the value stored
in CMOS.
2. Press + +
appears indicating a wrong memory configuration.
3. Press twice to exit and reboot the system.
The system boots with the new memory configuration.
1.8

IDE Hard Disk Support

The system board supports four IDE hard disks, or any other IDE
devices, through the two onboard PCI IDE interfaces. See Figure 1-2
for the location of the IDE interfaces.
Follow the instructions in the housing installation manual on how to
install a hard disk in the system. Connect the cables according to the
IDE hard disk configuration in Table 1-4.
Table 1-4 IDE Hard Disk Configuration
IDE Connector
HDD Channel 1
HDD Channel 2
1-18
A memory error message appears,
to enter Setup. A warning message
Master Slave
Hard disk 0 Hard disk 1
Hard disk 2 Hard disk 3/
IDE CD-ROM drive
User's Guide