Lighting - Invicta ARATOS 649000 Manual

Lighting

Lighting is "manual" and thus requires attention.
It is important to check whether flames are present once lit: if there are no flames, and the wood starts
to smoke, the stove should be stopped by pressing button A.
(flame visible).
Output Level.
The ignition cycle starts and continues for 20 minutes at Output Level 1 to allow for a gradual rise in temperature.
Keep the stove under surveillance during this time to ensure that the pellets are properly lit (general and
homogeneous burning of pellets without accumulation of unburnt pellets)
After the 20 minutes of the ignition cycle, the stove will change output setting every 2 minutes to increase output to
the desired level selected with [button B]
*: It may be useful to leave the hearth door open slightly during lighting, for additional airflow, but the stove should remain under
supervision.
It should be closed again once the volume of flame has visibly increased.
Page 25 sur
XD, on 14/05/2018
ARATOS Plug-in
Place the firelighters in the crucible and pour on a small quantity of pellets.
4. Ignite the set fire, close the hearth door *, wait until the pellets ignite correctly
5. Set [button B] to the desired
6. Start the stove by pressing on button A for a few seconds:
•
"Power On LED" lit
•
"Power Indicator Light" n°1, lit
41
stove
dual
model 6490 00