Switch Input Source; Software Operation - Feelworld LIVEPRO L1 User Manual

FX only woks on LIVEPRO L2 and leads to PTZ control menu on device.
Camera: choose the desired camera from index 1~8, or ALL. One device is able
to connect up to 8 PTZ cameras.
Load View: from View index 1~11
Save View: to View index 1~11
In terms of "View" it means lens position and zoom setting on PTZ control.
Control: POS（position）and ZOOM（Zoom in/out）
Position control: Use X knob to control camera lens move left and right, Y knob
to move camera lens up and down.
Zoom control: Use Y knob to zoom in and out.
Enable: Enable or disable the LAN communication of Camera 1~8
IP Setting: Match the IP address of those PTZ cameras connecting to
LIVEPRO L2

3.Switch Input Source

After selecting transition effect and switch mode
. Under Fast+Time mode, pushing green button will switch the input source
1
in the selected time with set transition effect. After switching, green turns to red.
. Under T-Bar mode, pushing green button, it will flash and push T-Bar to the
2
end (left or right), the source will be switched with selected transition effect.
After switching, green turns to red.
Note: When T-Bar is not in the end position, no source can be selected

4.Software Operation

Connection Way
1. Connect the LAN port of the computer to the LAN port of LIVEPRO L1,
manually set the IP for the computer and LIVEPRO L1, you can connect
LIVEPRO L1 and the computer to the same LAN.
2. Connect the computer and LIVEPRO L1/L2 to the same router, only need to
14