Abit Fatal1ty FP-IN9 SLI User Manual page 51

- CPU FanEQ Temp. Tolerance
This item sets the temperature tolerance range for the item "CPU FanEQ Target Temp.".
- CPU FanEQ Start Control
This item sets the speed ratio for the 4-pin CPU fan assembly connected at "CPUFAN1" fan
power connector to start running.
- CPU FanEQ Stop Control
This item sets the lowest speed ratio for the 4-pin CPU fan assembly connected at "CPUFAN1"
fan power connector to run at when the CPU temperature detected is lower than the value of
item "CPU FanEQ Target Temp." plus the value of item "CPU FanEQ Temp. Tolerance".
In the situation when the CPU temperature detected is higher than the value of item "CPU
FanEQ Target Temp." plus the value of item "CPU FanEQ Temp. Tolerance", the speed ratio for
the 4-pin CPU fan assembly connected at "CPUFAN1" fan power connector will first run at the
speed ratio set by the item "CPU FanEQ Start Control", and then up to 100%.
The 3-pin fan assembly connected at this 4-pin "CPUFAN1" fan power
※
connector will have no speed control function.
SYS FanEQ Control
This item allows you to control the SYSFAN speed. When set to [Enabled], the following items
become selectable.
- SYS FanEQ Reference Temp.
This item sets the reference point for taking temperature. The options are "System" and "CPU".
In the situation when connecting a 3-pin CPU fan assembly, and you still want
※
the speed control function to take effect, you must:
1. Plug the 3-pin CPU fan assembly to "SYSFAN1" fan power connector.
2. Set the "SYS FanEQ Reference Temp." from the default "System" to "CPU".
- SYS FanEQ Target Temp.
This item sets the temperature mark for the "SYS FanEQ" function to take effect.
- SYS FanEQ Temp. Tolerance
This item sets the temperature tolerance range for the item "SYS FanEQ Target Temp.".
- SYS FanEQ Start Control
This item sets the speed ratio for the 3-pin fan assembly connected at "SYSFAN1" fan power
connector to start running.
- SYS FanEQ Stop Control
This item sets the lowest speed ratio for the 3-pin fan assembly connected at "SYSFAN1" fan
power connector to run at when the temperature of "SYS FanEQ Reference Temp." detected is
lower than the value of item "SYS FanEQ Target Temp." plus the value of item "SYS FanEQ
Temp. Tolerance".
In the situation when the temperature of "SYS FanEQ Reference Temp." detected is higher than
the value of item "SYS FanEQ Target Temp." plus the value of item "SYS FanEQ Temp.
Tolerance", the speed ratio for the 3-pin fan assembly connected at "SYSFAN1" fan power
connector will first run at the speed ratio set by the item "SYS FanEQ Start Control", and then
up to 100%.
FP-IN9 SLI 2-21