Table of Contents
Advertisement
If WizFi250 was set successfully, you will see the success message as below.
Then you can select DHCP mode or Static mode. In this example we chose DHCP mode. When using DHCP, it is
not required to select IP information.
Enter a Password and then Select the <Join> button you want to associate to SSID.
If you can see "Device Started. Web server and access point stopped. See UART for further information."
message in the web browser and "Successfully joined" message in the serial terminal, WizFi250 is associated to
AP successfully.
This picture is serial message when WizFi250 is associated to AP successfully.
2020/11/26 12:13
48/81
WizFi250 Programmer's Guide
Advertisement
Table of Contents
