Table of Contents
Advertisement
AT+MWIFIPS
Format:
AT+MWIFIPS=<Action>,<Delay>
Meaning: Wi-Fi Power Save Enable/Disable
Wi-Fi power save mode can be selected through this command.
<Action> : Wi-Fi Power Save Mode (Required)
Parameter
0
Wi-Fi Power Save Mode Disable
1
Wi-Fi Power Save Mode Enable
2
Enables power save mode while attempting to maximize throughput
* To using Wi-Fi Power Save Mode, WizFi250 has to connect to Access Point. And WizFi250 can only use
this mode in station mode.
<Delay > : Return to Sleep Delay
If it is set with a bigger value, the performance will improve but the power consumption will rise.
Action
0
1
2
* This parameter is used only to set 2 of <Action> parameter.
* It must be set to a multiple of 10. When set to 0, the timeout period default to 2 beacon intervals
(approximately 204ms).
* It can be set to 0 ~ 90
Response:
[OK]
Format:
AT+MWIFIPS=?
Meaning: Get Current Wi-Fi Power Save Status
2020/11/26 12:13
Meaning
N/A
N/A
Required
26/81
Application
WizFi250 Programmer's Guide
Advertisement
Table of Contents
