ABB RELION REB500 Applications Manual page 22

Section 4
Configuring bay protection using HMI500
IEC18000645 V1 EN-US
Figure 8:
The version number of the bay protection configuration module is shown in the bottom left-
hand corner.
IEC18000646 V1 EN-US
Figure 9:
Table 8:
Dialog box term
Configuration
Measurements
Test
Read- Write
Read- only
Table 9:
Dialog item
Configured
functions
Available
parameters
Used parameters
16
Area below tabs – sensitive for selection of statistical evaluation
Status indication of BP function
Status indication of BP Function – Mode
Description
The dialog is in the protection function configuration or setting mode.
The dialog was started in the measurement display mode.
Not implemented in this version.
The user can edit and save settings.
The user cannot edit settings.
Status indication of BP Function – Statistics
Description
Number of instances created by the user for this bay unit. The maximum
number is 128.
The number of memory locations available for protection function
settings in the entire system.
Number of protection function settings used by the present bay unit.
© 2019 - 2020 Hitachi Power Grids. All rights reserved
17000026-IEC18000646-1-en.vsdx
1MRK 505 403-UEN Rev. C
17000025-IEC18000645-1-en.vsdx
Bay protection functions REB500
Application manual