Hartzell HC-B3-2 Series Owner's Manual And Logbook page 153

(28) Install the rod end cap onto the threaded end of the push
rod spool.
NOTE:
(a) Apply Loctite
(b) Tighten the set screw.
(29) Apply Loctite
check nut will be located on the push rod spool next to
the bushing.
(30) Tighten the check nut against the bushing to torque
indicated in Table 3-2.
(31) Attach engine mounted beta system control hardware
to rod end fitting and adjust per airframe or engine
manufacturer's instructions.
(32) Install the beta light switch against the pin per airframe
manufacturer's instructions.
(33) Install the spacer and self-locking nut onto the front
of the rod that protrudes through the front of the pitch
change rod and piston.
(a) Follow the airframe manufacturer's instructions for
making pitch control adjustments.
(34) If the propeller is equipped with an ice protection
system that uses components supplied by Hartzell
Propeller Inc., refer to Hartzell Propeller Inc. Propeller
Ice Protection System Manual 180 (30-61-80) for
applicable instructions and technical information.
(35) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder's Instructions for Continued
Airworthiness (ICA).
INSTALLATION AND REMOVAL
Propeller Owner's Manual
Make sure the rod end cap is bottomed on the
end of the push rod spool.
272 to the set screw threads.
®
272 to the push rod threads where the
®
139
61-00-39
Rev. 17 Apr/20
Page 3-53