Hartzell HC-B3-2 Series Owner's Manual And Logbook page 152

CAUTION:
(23) Install the rod end cap onto the threaded end of the push
rod spool.
NOTE:
(a) Mark the location of the set screw on the rod and
then remove the end cap unit.
(b) File a flat, tangent to the rod, no deeper than the
depth of the threads at the marked location of the set
screw. Refer to Figure 3-17.
(24) Install the check nut onto the threaded end of the push
rod spool.
(25) Install the bushing onto the threaded end of the push rod
spool.
(26)Install the rod end fitting onto the threaded end of the
push rod spool.
(27) Install the C-3317-006 O-ring in the cavity at the rear
end of the push rod spool.
PUSH ROD SPOOL
INSTALLATION AND REMOVAL
Propeller Owner's Manual
THE ROD END CAP MUST BOTTOM
ON THE PUSH ROD SPOOL WHEN
INSTALLED.
Do not tighten the set screw in the rod end
cap.
Filed Rod for Set Screw
Figure 3-17
139
FILED FLAT
61-00-39
Rev. 17 Apr/20
Page 3-52