Refrigerator Features; Convertible Drawer Temperature Control (On Some Models) - KitchenAid KRSC703HPS Owner's Manual

Hide thumbs Also See for KRSC703HPS:
Table of Contents

Advertisement

Available languages

Available languages

Ethylene production and sensitivity varies depending on the type
of fruit or vegetable. To preserve freshness, it is best to separate
produce with sensitivity to ethylene from fruits that produce
moderate to high amounts of ethylene.
Sensitivity to
Apples
Asparagus
Berries
Broccoli
Cantaloupe
Carrots
Citrus Fruit
Grapes
Lettuce
Pears
Spinach
Installing the Produce Preserver
CAUTION: IRRITANT. MAY IRRITATE EYES AND SKIN.
DANGEROUS FUMES FORM WHEN MIXED WITH OTHER
PRODUCTS.
MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES FORM
WHEN MIXED WITH OTHER PRODUCTS.
Do not mix with cleaning products containing ammonia, bleach, or
acids. Do not get in eyes, on skin or clothing. Do not breathe dust.
Keep out of reach of children.
FIRST AID TREATMENT: Contains potassium permanganate. If
swallowed, call a Poison Control Center or doctor immediately. Do
not induce vomiting. If in eyes, rinse with water for 15 minutes. If
on skin, rinse with water.
The Produce Preserver pouches should be installed in their
housing, which is located along an interior side wall of the crisper
or convertible drawer.
NOTE: For best performance, always use two pouches.
1. Remove the Produce Preserver pouches from their
packaging.
2. Lift up on the housing in order to remove it from its mounting
tab along the wall.
3. Open the housing by pulling up and out on the back of the top
of the housing.
4. Place both pouches inside the housing; then snap the housing
back together.
5. Place the housing back on the mounting tab along the wall.
Ethylene
Ethylene
Production
High
Very High
Medium
Very Low
Low
Low
High
Very Low
Medium
High
Low
Very Low
Medium
Very Low
Low
Very Low
High
Very Low
High
Very High
High
Very Low
Installing the Status Indicator
The Produce Preserver comes with a status indicator, which
should be activated and installed at the same time the pouch is
installed.
1. Place the indicator facedown on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until
the bubble pops to activate the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE: The cap will not close easily if the indicator's rear
bubble has not been popped.
Replacing the Produce Preserver Pouches
The disposable pouches should be replaced every 6 months,
when the status indicator has completely changed from white to
red.
To order replacements, see the contact information in the Quick
Start Guide. Order part number W10346771A or FRESH1.
1. Remove the used pouches from the produce preserver
housing.
2. Remove the old status indicator.
3. Install the new pouches and status indicator using the
instructions in the previous sections.

REFRIGERATOR FEATURES

Convertible Drawer Temperature
Control (on some models)
The control can be adjusted to properly chill meats or vegetables.
The air inside the pan is cooled to avoid "spot" freezing and can
be set to keep meats at the National Livestock and Meat Board
recommended storage temperatures of 28° to 32°F (–2° to 0°C).
To store meat:
Set the control to one of the three Meat settings to store meat at
its optimal storage temperature.
To store vegetables:
Set the control to Veg to store vegetables at their optimal storage
temperatures.
NOTE: If food starts to freeze, move the control to the right (less
cold), toward the Veg setting. Remember to wait 24 hours
between adjustments.
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents