Door Closing And Alignment - KitchenAid KRSC703HPS Owner's Manual

4. If your model has water dispensing in the door, connect the
water dispenser tubing. For the connection, push the tubing
into the dispenser tubing until black mark touches the face of
fitting as shown below.
A. Face of fitting
5. Connect the wiring as shown below.
A. Wiring plugs
B. Wiring clip
6. Reinstall the wiring clip & the bracket wire using a 1/4"
hexagonal head socket wrench.
7. Connect the wiring plugs from the bracket wire.
8. Lift the refrigerator door enough to insert the door onto the
bottom hinge pin as shown below.
IMPORTANT: Hold the door while hinge is being installed.
9. Close the refrigerator door to align and reinstall the top hinge.
Use a TORX T30 screwdriver to tighten the screws as shown
below.
A. Do not remove A screws
IMPORTANT: Provide additional support for the door while top
hinge is being reinstalled. Do not depend on the door magnets
to secure the door to the cabinet.
C. Grommets

Door Closing and Alignment

Your refrigerator has two front adjustable wheels.
These are used to level the refrigerator under uneven floor
conditions or to allow the doors to close more easily. Please follow
the instructions below:
1. Use a bubble level to check levelness of floor where the rear
side of the refrigerator will rest. If the refrigerator is not
leveled, adjust or add the shim on flooring to create a leveled
floor for the rear side wheels. A leveled rear side prevents the
refrigerator cabinet from forming a twist.
2. Place the refrigerator into its final location in the kitchen and
open both doors.
3. Fully open both doors.
4. If your model has water dispensing, please open the water
filter door by pulling it toward you as shown below. It is not
necessary to remove the water filter itself.
5. Pull the base grille toward you from the sides and then from
the center until it dislodges.
6. To remove the base grille, twist and pull the right side until this
side passes underneath the refrigerator door. Then pull the left
side of the base grille for complete removal.
A. Pull to the right for
extraction
7. Raise the wheels while one person pushes on the refrigerator
to lift from front side. Use the bubble level on top of the
refrigerator or on its side to level the refrigerator. Check
bubble level and at the same time observe the gaps and
squareness to the adjacent cabinets, furniture, or trim. If
adjacent furnishings are not level, it may not be possible to
achieve even gaps when refrigerator is level. Continue
adjusting until all four corners are steady without rock.
8. Use a 3/8" nut driver to turn the leveling screws located in both
sides of the refrigerator as shown below. Depending on
uneven floor conditions, you must turn one or both screws to
the right or left several times to raise or lower the refrigerator.
9. Close both doors and check that they close as easily as you
like. If not, turn both screws to the right to raise the refrigerator
by tilting it more to the back until the doors close as easily as
you like.
B. Twist and pass
underneath door
21